Next: Errors in Recipes, Previous: Recipe Execution, Up: Writing Recipes in Rules [Contents][Index]
GNU make knows how to execute several recipes at once. Normally,
make will execute only one recipe at a time, waiting for it to finish
before executing the next. However, the ‘-j’ or ‘--jobs’ option
tells make to execute many recipes simultaneously. You can inhibit
parallelism for some or all targets from within the makefile (see Disabling Parallel Execution).
On MS-DOS, the ‘-j’ option has no effect, since that system doesn’t support multi-processing.
If the ‘-j’ option is followed by an integer, this is the number of recipes to execute at once; this is called the number of job slots. If there is nothing looking like an integer after the ‘-j’ option, there is no limit on the number of job slots. The default number of job slots is one, which means serial execution (one thing at a time).
Handling recursive make invocations raises issues for parallel
execution. For more information on this, see Communicating Options to a Sub-make.
If a recipe fails (is killed by a signal or exits with a nonzero
status), and errors are not ignored for that recipe (see Errors in Recipes), the remaining recipe lines to remake the same
target will not be run. If a recipe fails and the ‘-k’ or
‘--keep-going’ option was not given (see Summary of Options), make aborts execution. If make
terminates for any reason (including a signal) with child processes
running, it waits for them to finish before actually exiting.
When the system is heavily loaded, you will probably want to run fewer jobs
than when it is lightly loaded. You can use the ‘-l’ option to tell
make to limit the number of jobs to run at once, based on the load
average. The ‘-l’ or ‘--max-load’
option is followed by a floating-point number. For
example,
-l 2.5
will not let make start more than one job if the load average is
above 2.5. The ‘-l’ option with no following number removes the
load limit, if one was given with a previous ‘-l’ option.
More precisely, when make goes to start up a job, and it already has
at least one job running, it checks the current load average; if it is not
lower than the limit given with ‘-l’, make waits until the load
average goes below that limit, or until all the other jobs finish.
By default, there is no load limit.
Next: Errors in Recipes, Previous: Recipe Execution, Up: Writing Recipes in Rules [Contents][Index]