Next: , Up: M4 Quotation


8.1.1 Active Characters

To fully understand where proper quotation is important, you first need to know what the special characters are in Autoconf: `#' introduces a comment inside which no macro expansion is performed, `,' separates arguments, `[' and `]' are the quotes themselves, `(' and `)' (which M4 tries to match by pairs), and finally `$' inside a macro definition.

In order to understand the delicate case of macro calls, we first have to present some obvious failures. Below they are “obvious-ified”, but when you find them in real life, they are usually in disguise.

Comments, introduced by a hash and running up to the newline, are opaque tokens to the top level: active characters are turned off, and there is no macro expansion:

     # define([def], ine)
     =># define([def], ine)

Each time there can be a macro expansion, there is a quotation expansion, i.e., one level of quotes is stripped:

     int tab[10];
     =>int tab10;
     [int tab[10];]
     =>int tab[10];

Without this in mind, the reader might try hopelessly to use her macro array:

     define([array], [int tab[10];])
     array
     =>int tab10;
     [array]
     =>array

How can you correctly output the intended results1?


Footnotes

[1] Using defn.