8.1.1 Active Characters

To fully understand where proper quotation is important, you first need to know what the special characters are in Autoconf: ‘#’ introduces a comment inside which no macro expansion is performed, ‘,’ separates arguments, ‘[’ and ‘]’ are the quotes themselves, and finally ‘(’ and ‘)’ (which M4 tries to match by pairs).

In order to understand the delicate case of macro calls, we first have to present some obvious failures. Below they are “obvious-ified”, but when you find them in real life, they are usually in disguise.

Comments, introduced by a hash and running up to the newline, are opaque tokens to the top level: active characters are turned off, and there is no macro expansion:

     # define([def], ine)
     =># define([def], ine)

Each time there can be a macro expansion, there is a quotation expansion, i.e., one level of quotes is stripped:

     int tab[10];
     =>int tab10;
     [int tab[10];]
     =>int tab[10];

Without this in mind, the reader might try hopelessly to use her macro array:

     define([array], [int tab[10];])
     array
     =>int tab10;
     [array]
     =>array

How can you correctly output the intended results¹?