---

15.2 Flow

Command: defflow fstate [interrupt] ¶

(none)
Same as the flow command except that the default setting for new windows is changed. Initial setting is ‘auto’. Specifying flow auto interrupt has the same effect as the command-line options ‘-fa’ and ‘-i’. Note that if ‘interrupt’ is enabled, all existing displays are changed immediately to forward interrupt signals.

Command: flow [fstate] ¶

(C-a f, C-a C-f)
Sets the flow-control mode for this window to fstate, which can be ‘on’, ‘off’ or ‘auto’. Without parameters it cycles the current window’s flow-control setting. Default is set by ‘defflow’.