14.1 Errors reported by the Stage 1

The general way that the Stage 1 handles errors is to print an error string and then halt. Pressing <CTRL>-<ALT>-<DEL> will reboot.

The following is a comprehensive list of error messages for the Stage 1:

Hard Disk Error

The stage2 or stage1.5 is being read from a hard disk, and the attempt to determine the size and geometry of the hard disk failed.

Floppy Error

The stage2 or stage1.5 is being read from a floppy disk, and the attempt to determine the size and geometry of the floppy disk failed. It's listed as a separate error since the probe sequence is different than for hard disks.

Read Error

A disk read error happened while trying to read the stage2 or stage1.5.

Geom Error

The location of the stage2 or stage1.5 is not in the portion of the disk supported directly by the BIOS read calls. This could occur because the BIOS translated geometry has been changed by the user or the disk is moved to another machine or controller after installation, or GRUB was not installed using itself (if it was, the Stage 2 version of this error would have been seen during that process and it would not have completed the install).