next up previous contents
Next: ! command Up: Command descriptions Previous: Command descriptions   Contents


Command Summary

*
Comment line.

!
Pass a command to the operating system.

<
Batch mode.

>
Direct the ``standard output'' to a file.

AC
Performs a small signal AC (frequency domain) analysis. Sweeps frequency.

ALARM
Select points in circuit check against limits.

ALTER
Perform analyses in queue. Changes follow. (Not implemented.)

BUILD
Build a new circuit or change an existing one.

CHDIR
Change current directory.

CLEAR
Delete the entire circuit, titles, etc.

DC
Performs a nonlinear DC analysis, for determining transfer characteristics. Sweeps DC input or component values.

DELETE
Delete a part, or group of parts.

DISTO
SPICE command not implemented.

EDIT
Edit the circuit description using your editor.

END
Perform analyses in queue. New circuit follows. (Implemented incorrectly.)

EXIT
Exits the program. (Same as quit.)

FANOUT
List by node number, the branches that connect to each node.

FAULT
Temporarily change a component.

FOURIER
Transient analysis, with results in frequency domain. (Different from SPICE.)

GENERATOR
View and set the transient analysis function generator.

GET
Get a circuit from a disk file. Deletes old one first.

IC
Set transient analysis initial conditions. (Not implemented.)

INCLUDE
Include a file from disk. Add it the what is already in memory.

INSERT
Insert a node number. (Make a gap.)

LIST
List the circuit on the console.

LOG
Save a record of commands.

MARK
Mark this time point, so transient analysis will restart here.

MERGE
Get a file from disk. Add it the what is already in memory.

MODIFY
Change a value, node, etc. For very simple changes.

NODESET
Preset node voltages, to assist convergence. (Not implemented.)

NOISE
SPICE command not implemented.

OP
Performs a nonlinear DC analysis, for determining quiescent operating conditions. Sweeps temperature.

OPTIONS
View and set system options. (Same as set.)

PAUSE
Wait for key hit, while in batch mode.

PLOT
Select points in circuit (and their range) to plot.

PRINT
Select which points in the circuit to print as table.

QUIT
Exits the program. (Same as exit.)

SAVE
Save the circuit in a file.

SENS
SPICE command not implemented.

STATUS
Display resource usage, etc.

SWEEP
Sweep a component. (Loop function.)

TEMP
SPICE command not implemented.

TF
SPICE command not implemented.

TITLE
View and create the heading line for printouts and files.

TRANSIENT
Performs a nonlinear transient (time domain) analysis. Sweeps time.

UNFAULT
Undo faults.

UNMARK
Undo mark. Release transient start point.

WIDTH
Set output width.


next up previous contents
Next: ! command Up: Command descriptions Previous: Command descriptions   Contents
Al Davis 2002-03-26