Re: GNATS installation question

[Hans-Albert Schneider <Hans-Albert dot Schneider at mchp dot siemens dot de>]

>>>>> "HG" == Giat, Hana <Hana_Giat@icomverse.com> writes:

    HG> Although, i cannot spawn the deamon because "520 You are
    HG> not on the host access list: stdin (stdin)."

Do you try to start it manually, from the command line?  It is
intended to be started by inetd (or xinetd, or a similar program).
You should need root privileges to edit its configuration file,
and also for step 5) below.


I am assuming inetd for the following.  My /etc/inetd.conf
contains a line like this:

#
# GNATS Problem Report System
#
support    stream  tcp     nowait  gnats        /usr/local/libexec/gnats/gnatsd gnatsd

Make sure that:

1) The 1st field ("support" above) contains a known service; that
   is, /etc/services contains a line for it.  It could also be
   the corresponding NIS map, or some LDAP entry, or whatever
   your system uses instead.  Your system administrator should know.

2) The 5th field ("gnats") is the username of your GNATS user.

3) The 6th field ("/usr/local/libexec/gnats/gnatsd") is the full
   pathname of the gnatsd program.  You do not need to use
   TCP-wrapper or something like this, as gnatsd does something
   similar through gnats.conf.

4) Check the man page for inetd.conf and reorder the fields, if
   needed.


5) Tell the running inetd to reread its configuration file, by
   sending it a "kill -HUP".



Hope this helps,

     Hans-Albert

-- 
Hans-Albert Schneider		<Hans-Albert.Schneider@mchp.siemens.de>
Siemens AG			phone:	(+49) 89 636 45445
Corporate Technology		fax:	(+49) 89 636 42284
Munich, Germany
 -- To get my public PGP key, send me a mail with subject "send key" --